| |
Input Voltage:
Input Frequency:
Inrush Current:
Ripple and Noise:
Line Regulation:
Load Regulation:
Hold Up Time:
Power Good:
Power Fail:
Power On:
Efficiency:
Altitude:
Protection:
Temperature:
Humidity:
Connectors:
Dimensions:
MTBF: |
|
90~130VAC or 180~260VAC, auto switchable
47~63Hz
Not exceed 40A at 115VAC input or 80A at 230VAC input, at
cold start 25°C
Peak to peak ripple and noise for each output is < 1% of each output voltage at rated load 115~230VAC
< +/-1% at rated load with +/-10% change in input voltage
The output voltage load regulation is less than the values on
the table when each output loading changes +/-40% from 60%
rated load while all other outputs at 60% rated load
> 20ms at 115VAC input and rated load measured from the end of
the last charging pulse to when the main output drops down to
95% output voltage
Goes high 100~500ms after all DC output are ready
Goes low 0.5ms before any DC output falls
TTL compatible signal (active low) used to switch ON the main
output. When power on is disconnected from secondary
common, all outputs except +5Vsb are turned off
> 65% at nominal line and rated load
10,000 feet
Short Circuit: Hiccup mode function against short circuit or
over load conditions auto restarts when fault conditions are removed
Output: Built-in crowbar circuit automatically shuts down outputs
to avoid damaging external circuits. Trip point of O.V.P. circuit
is between 5.7~7.0V
Operating: 0~70°C
Storage: -40~+75°C
Operating: 5~95%; non-condensing at 40°C
AC Input/Output: Meets IEC 320/CEE 22 standard
ATX Connector: Alex 9358-20 or equivalent device
3.5" Disk Drive: AMP 1-480424-0/171822-4 or equivalent device
14.0 x 15.0 x 8.62 cm with +/-0.8mm and +/-0.4mm tolerance
between mounting holes
119,695 hrs. |
|
