|
Input Voltage:
Input Frequency:
Input Current:
Inrush Current:
Load Range:
Ripple and Noise:
Line Regulation:
Load reguration:
Hold Up Time:
Efficiency:
Protection:
Temperature:
Humidity:
Connectors:
Dimensions: |
|
The range of input voltage is from 90~264VAC
47~63Hz
The maximum input current is 0.65A at 115VAC or 0.32A
at 230VAC
The cold inrush current will limit less than 50A at 264VAC
input voltage
At factory, the output is checked between 4.9~5.1V (MPE-F40-05) /
11.76~12.24V (MPE-F40-12) / 23.5~24.5V (MPE-F40-24) /
47.04~48.96V (MPE-F40-48) at 60% rated load
The peak to peak ripple and noise is less than 50mV
(MPE-F40-05) / 120mV (MPE-F40-12) / 240mV (MPE-F40-24) /
480mV (MPE-F40-48). Measuring is done by 20MHz bandwidth
limited oscilloscope and terminated each output with
a 0.1μF ceramic capacitor and a 10μF electrolysis capacitor
at rated load, nominal line
The line reguration is less than +/-0.5% while measuring at rated
load and from 100VAC to 240VAC input voltage changing
The load reguration for output is less than +/-1%, measuring is done
by changing the output load +/-40% from 60% rated load
Hold up time is 8mS typical at 115VAC, full load
The efficiency is 78% (MPE-F40-05) / 84% (MPE-F40-12) / 86%
(MPE-F40-24) / 88% (MPE-F40-48) typical while measuring is at nominal line and rated load
The power supply will go into hiccup mode against short circuit or
over load conditions, and will do auto-recovery while faulty
conditions are removed
0~+50°C (operating); -40~+85°C (storage)
5~95% non-condensing
I/P Connector: Molex housing 09-50-3031 and Molex 2878
series crimp terminal
O/P Connector: Molex housing 09-50-3031 and Molex 2878 series
crimp terminal
10.16 x 5.08 x 3.048 cm; tolerance specified is +/-0.4mm |
|
