Input Voltage:
Input Current: Inrush Current: Load Range:
Ripple And Noise:
Line Regulation:
Load Regulation:
Power On/Off:
Power Good Signal:
Power Fail Signal:
Efficiency:
Altitude:
Altitude: Protection:
Temperature:
Humidity: Connectors:
Dimensions:
|
|
The range of input voltage is from 30~120VDC, nominal input voltage is 48 and 90VDC The maximum is 7A at 30VDC input The inrush current is less than 70A at 30VDC input At the factory, the +5V output is set between 5.08V to 5.13V and all output at 60% rated load; the other outputs are checked to be within the accuracy range. The maximum total combined output power on the +3.3V and +5V rails is 70W. The max. load cannot exceed 120W The peak to peak ripple and noise for +5V, +3.3V output are less than 100mV for +5Vsb is 120mV, for +12V is less than 120mV , for -12V is less than 200mV at ranted load and nominal input, which is measured by a 20MHz bandwidth limited oscilloscope and the each output is connected with a 0.47μF capacitor The line regulation is less than +/-2.5% at rated load with +/-10% change in input voltage The load regulation for +5V is less than +/-2 %, for +12V is less than ±5%, for -12V +/-5%, + 3.3V is less than +/-5% while the measuring is done by changing the measured output loading +/-40% from 60% rated load , and keep other output is at 60% rated load The power supply will start-up when the power On/Off pin be connected to secondary GND The power is turned on, the power good signal will go high between 100ms to 500ms after all output DC voltage are within regulation limits The power fail signal will go low at least 1ms before any of the output voltages fall below the regulation limits The efficiency is higher than 70% while measuring at nominal line and rated load The efficiency is higher than 70% while measuring at nominal line and rated load Will operate properly at any altitude between 0 to 10000ft The power supply will generate the hiccup mode to protect itself against short circuit or over load condition, and will return to normal after wrong condition is removed 0~50°C, output power is 120W forced air cooling, 85W convection cooling (Operating) -20°~+70°C (Storage) 10~90% non-condensing DC Input: Dinkle DT-35-B01W-03 or equivalent DC Output: Molex 5273-14A or equivalent DC Output: Molex 5045-03A or equivalent Power Good Output: Molex 5045-02A or equivalent Fan Output: Molex 5045-02A or equivalent 8.38 x 15.24 x 3.81 cm; tolerance specified is +/-0.4mm |